![install fingerprint reader install fingerprint reader](https://docplayer.net/docs-images/46/21663839/images/page_5.jpg)
Take the other half of the finger print wire inside the chassis and plug into the outlet located on the ribbon cable pictured below. Now you can reinstall the speaker grill cover, Assuming its ran correctly. You should then be able to put the reader into the chassis recess shown with minimal slack left over. There is a slight groove the cable runs through so it will not be pinched. 1st run the finger print cable between the chassis speaker and the plastic speaker mount as shown in the picture below. Now you can begin installing the finger print reader. When removing the plastic cage you will need to slide the plastic assembly slightly towards the main board in order to get the tabs from underneath the mouse board. You can also unplug the cmos battery from the main board. In order to do this you will need to remove the single screw to the left of the cmos battery. Now go into the inside of the chassis and remove the plastic cage pictured below. You will see where 1 of the 2 handle shims goes. Remove the 4 screws pictured below to remove the speaker cover. You can now remove the bottom half of the handle retainer and move the handle out of the way. This is right above the word “Panasonic” in white in the above image. Next remove the large screw that holds the left side of the handle assembly. Now remove the bottom cover of the laptop. The image below is labeled L for long screws and S for short screws. Remove the following screws from the bottom of the laptop. Begin by removing the Battery from the laptop.